Technical information
36 37
www.CurrieTech.com
OM Chain Drive Scooters - 2012.indd
Modied 05/25/2012
Currie Technologies
®
Currie Technologies
®
NOTES:_______________________________________________________
_____________________________________________________________
_____________________________________________________________
_____________________________________________________________
_____________________________________________________________
_____________________________________________________________
_____________________________________________________________
_____________________________________________________________
___________________________________________________________
Section 6 - PRE-RIDE CHECKLIST
It is recommended that you perform each of these checks before each and every ride.
TIRES
□ Check tires for any cuts or unusual wear.
□ Check tire pressure and inflate to the pressure recommended on the sidewall.
HANDLEBARS and FRAME
□ Inspect for bent, damaged or cracked welds and tubing caused by aggressive
riding.
□ Ensure the handlebars are properly aligned and secured tight enough so that you
cannot twist them out of alignment.
NUTS and BOLTS
□ Inspect and tighten all fasteners before each and every ride.
□ If unsure on how to inspect and tighten fasteners, seek advice from an authorized
and experienced mechanic.
BRAKES
□ Ensure brake control cable(s) are lubricated, correctly adjusted and display no
obvious wear.
□ Ensure brake control lever(s) are not binding and the clamps are tightly secured to
the handlebar.
□ Squeeze the brake lever(s) to make sure that it does not bottom out on the handle-
bar and the brake(s) holds the scooter from being pushed forward.
□ Squeeze the brake lever(s) to ensure the brake inhibitor(s) stop the motor.
□ Ensure brake shoe pads are not worn out and are correctly positioned.
ELECTRICAL SYSTEM
□ Be sure the batteries are fully charged by using the battery gauge (colored LED’s)
on the throttle.
□ Ensure your battery pack is properly installed in your scooter with the deck plate
attached and secured.
□ Ensure the accelerator are secure, in good condition and working properly.
RIDING GEAR
□ Always wear an approved helmet.
□ Always wear proper protective equipment such as; eye protection (goggles or face
shield), gloves, boots, long sleeved shirt or jacket and long pants.
□ Never operate this product barefoot or in sandals as this increases the risk of
injury.
□ Always obey all local traffic laws
OM eZip Chain Drive Scooters 2010 rev-1
FCC INSTRUCTIONS
Warning: Changes or modifications to the charger not expressly approved
by the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.