Technical information
26 27
www.CurrieTech.com
OM Chain Drive Scooters - 2012.indd
Modied 05/25/2012
Currie Technologies
®
Currie Technologies
®
6. Set the motor into the empty
battery tray.
7. Loosen and remove both axle
nuts with a 15mm wrench (Ref
Photo B).
8. Loosen and remove the two
5mm motor plate fixing bolts.
(Ref Photo C, D)
9. The rear wheel with the sprock-
et, chain and motor plate can
now be removed from the rear
of the frame.
Photo B
Photo C
Photo D
Photo E
Photo F
7. Loosen and remove both 15mm
axle nuts. (Ref Photo E)
8. Loosen and remove both 10mm
chain tensioners. (Ref Photo F)
9. Push the wheel all the way for-
ward in the frame to allow you
to remove the chain from the
motor sprocket.
10. The rear wheel along with
sprocket, chain, band brake
assembly and the rear half of
the chain guard can now be
removed from the rear of the
frame.
REAR WHEEL & DRIVE ASSEMBLY
REMOVAL
500CD, 650CD, 750CD AND 900CD
SERIES SCOOTERS
1. Turn the power switch to the
“OFF” position.
2. Remove seat tube from the
frame.
3. Remove both the deck and rear
fender from the frame.
4. Remove and disconnect the
battery pack.
5. Remove the motor from the
motor plate by remove the three
5mm bolts (Ref Photo A). Set
the bolts and T-nuts aside for
now.
Photo A