Technical information
24 25
www.CurrieTech.com
OM Chain Drive Scooters - 2012.indd
Modied 05/25/2012
Currie Technologies
®
Currie Technologies
®
Photo B
Photo A
Photo C
Photo D
REAR WHEEL & DRIVE ASSEMBLY
REMOVAL
300, 4.0 AND 400
SERIES SCOOTERS
1. Turn the power switch to the
“OFF” position.
2. Remove seat tube from the
frame.
3. Remove both the deck and rear
fender from the frame.
4. Remove chain guard. (Ref Pho-
tos A, B)
5. Disconnect the brake cable
from the band brake actuator
arm by removing the 10mm nut
and washer (Ref Photo C) from
the cable pinch bolt. The brake
cable has an end cap which will
keep the pinch bolt and spring
from coming completely off the
cable. Do not remove it.
6. Remove the band brake fixing
bolt using a 4mm hex key
wrench (or Phillips screwdriver)
and an 8mm wrench (Ref Photo
D). This bolt also holds the rear
cable hanger in place.
WHEEL REMOVAL
FRONT WHEEL REMOVAL
300, 4.0, 400, 500CD, 650CD, 750CD
AND 900CD SERIES SCOOTERS
1. Detach the V-Brake, if your
scooter was so equipped, (Ref
Photo A) by removing the brake
noodle (silver tube) from the
brake arm.
2. Loosen the axle nuts. (Ref
Photo B)
3. Remove the safety washers
from the dropouts. (Ref Photo
C)
4. Remove the front wheel from
the forks.
Be sure the
scooter does
not fall over and
cause damage to
itself or to you!
WARNING
!
Photo A
Photo B
Photo C