Technical data

IEC09000357-1-en.vsd
IEC09000357 V1 EN
Figure 11: Select the TCP/IP protocol and open Properties
4. Select Obtain an IP address automatically if the parameter DHCPServer is set
to Enabled in the IED.
IEC09000358-1-en.vsd
IEC09000358 V1 EN
Figure 12: Select: Obtain an IP address automatically
5. Select Use the following IP address and define IP address and Subnet mask if the
front port is used and if the IP address is not set to be obtained automatically by
the IED, see Figure 13. The IP address must be different from the IP address
chosen for the IED.
1MRK 511 261-UUS A Section 4
Setting up a project
650 series ANSI 35
Engineering Manual