Technical data

The IED restarts automatically when writing an IED configuration
where changes have been made to, for example, configuration
parameters. It is not possible to communicate with the IED during the
restart.
The IED does not restart after reconfiguring IEC61850 (regardless of
whether the protocol is enabled or disabled prior to reconfiguring). The
IED will reboot at the next PCM600 to IED write operation only in
case there are errors while configuring the IEC61850 protocol at the
most recent attempt.
Section 3 1MRK 511 261-UUS A
Engineering process
26 650 series ANSI
Engineering Manual