Technical data

IEC10000172.vsd
IEC10000172 V1 EN
Figure 74: Configuring hardware channels directly to the function blocks
IEC10000173.vsd
IEC10000173 V1 EN
Figure 75: CMT: Hardware channels appearing in the Communication
Management Tool
2. Right-click the IED in the plant structure and select Communication Management
to start the Communication management tool.
3. Select the DNP3 protocol from the new window and click OK.
Figure 76 presents
the design of the two container windows, which open after the selection of DNP3.
• The right window shows tabs for possible communication channels.
• The left window has a drop down menu for signal selection and buttons for
signal movement, see Figure 76.
1MRK 511 261-UUS A Section 9
DNP3 communication engineering
650 series ANSI 119
Engineering Manual