Technical data

IEC11000425-1-en.vsd
IEC11000425 V1 EN
Figure 73: Selecting the signals into the DNP signal list
9.3 Configuring DNP3 protocol signals
1. Save the actual project configuration in PCM600 to make all signals visible for
CMT.
Direct configured hardware channels in the application
configuration (see Figure 74) appear in CMT (see Figure 75). Do
not configure these hardware channels to be sent by DNP3, as they
are not event-handled.
Section 9 1MRK 511 261-UUS A
DNP3 communication engineering
118 650 series ANSI
Engineering Manual