Technical data

If a client is defined for GOOSE receive then at least one cross in
SMT is required to be able to write the configuration to the IED.
Be sure to set the setting Operation to Enabled in PST for all
included GOOSE receiving function blocks in the application
configuration to enable GOOSE communication.
6. Write the configuration to the IED, see Figure 68.
Note that the engineered data is written to the IED when executing
a common Write to IED operation.
1MRK 511 261-UUS A Section 7
IEC 61850 communication engineering
650 series ANSI 109
Engineering Manual