HOSPITALITY REMOTE CONTROL Programming Manual and User Guide
Pair or Unpair A Remote Control 1. Initiate Learn Mode Pull down and release the TAU twice to enter learn mode. After the first tug, the drapery should start moving. The second tug should stop it. Fig. X 2. Connect the Remote Remove the back plate or desktop backing from the remove by prying it off carefully with a screwdriver. Fig. X Depress the “pairing” button on the back of the remote by pushing a pen or other object through the hole in the back of the remote.
Using the Remote Control OPEN- STOP (Top Left)- A press and release moves the sheer drapery to the full open position. A second press and release stops the sheer drapery. PRIVACY- A press and release moves the sheer drapery to the full closed position. OPEN-STOP (Bottom Left)- A press and release moves the blackout drapery to the full open position. A second press and release stops the blackout drapery. SLEEP- A press and release moves both the sheer and the blackout to the full closed position.
SAFETY INFORMATION WARNING Read all warnings and instructions prior to installing the E-Wand™. Failure to follow these instructions may result in property damage or serious personal injury. CAUTION Do not use this product for anything other than its intended use. Any usage of the parts of this kit outside of its intended purposes in not covered under the warranty. CAUTION Drapery parts may have sharp edges. Use gloves to prevent cuts or abrasions whenever removing or reinstalling drapery.
RF WARNING STATEMENT The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure condition without restriction. IC STATEMENT This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
been installed; (ii) Products which have not been regularly and properly serviced in accordance with the User’s Manual or which have otherwise been neglected; and (iii) ordinary wear and tear, service and maintenance and replacement items; (iv) the Product has been used, or attempted to be used, for other than the customary usage or for other than the Product’s intended use; (v) the Product has been subject to mishandling, misuse, or abuse; (vi) the product has suffered damage resulting from lightning, powe
