CONTROL BOX Installation Manual and User Guide
Placing the Control Box Installing the Control Box
Grouping Drapery with the control box The grouping feature is available on all units with a control box. Grouping allows users to control multiple units simultaneously with one manual command. Grouping also allows units to move together simultaneously when any one unit in the group has a sensor automated command triggered. 1. Enter Pairing Mode On each drapery you would like to group, pull down on the Pendant twice. After the first pull, the drapery should move. The second pull should stop it. Fig.
Using the Light & Temperature Sensors on the control housing Light Sensor Control Light Sensor LED Indicator Temperature Sensor Control Temperature Sensor LED Indicator Sensors Power Sensors Power LED Indicator Light Sensor Control - A press and release displays the current mode of the light sensor. A second press and release changes the mode of the automated movements triggered by the light sensor. Temperature Sensor Control- A press and release displays the current mode of the temperature sensor.
Sensor Modes The integrated light and temperature sensors have three possible modes: Off, Fully Automatic, and Semi-Automatic. Off- The device will not make any movement triggered by this sensor. Fully Automatic- The device will open and close the curtains based on the sensor readings. Semi-Automatic- The device will close the curtains based on sensor readings, but will not open them. These modes are indicated using the LEDs on the right of the control box.
SAFETY INFORMATION WARNING Read all warnings and instructions prior to installing the E-Wand™. Failure to follow these instructions may result in property damage or serious personal injury. CAUTION Do not use this product for anything other than its intended use. Any usage of the parts of this kit outside of its intended purposes in not covered under the warranty. CAUTION Drapery parts may have sharp edges. Use gloves to prevent cuts or abrasions whenever removing or reinstalling drapery.
RF WARNING STATEMENT This equipment complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated to provide a separation distance of at least 20 cm from all persons. Cet équipement est conforme aux limites d’exposition au rayonnement FCC / ISED établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé de manière à assurer une distance de séparation d’au moins 20 cm de toutes les personnes.
been installed; (ii) Products which have not been regularly and properly serviced in accordance with the User’s Manual or which have otherwise been neglected; and (iii) ordinary wear and tear, service and maintenance and replacement items; (iv) the Product has been used, or attempted to be used, for other than the customary usage or for other than the Product’s intended use; (v) the Product has been subject to mishandling, misuse, or abuse; (vi) the product has suffered damage resulting from lightning, powe
