Installation Guide
Installation GuideLightGrid Internal Node 2.x Series
www.gecurrent.com
© 2021 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the
General Electric Company and are used under license. Information provided is subject to change without
notice. All values are design or typical values when measured under laboratory conditions.
CTRL042 (Rev 11/23/21)
Questions
• Email: lightgridsupport@gecurrent.com
• Leave a Voicemail: 1-877-843-5590
• The Internal Node is supplied with 3 identical
labels. One label is axed on the node housing.
The other two labels packaged with each node are
to be axed on a visible location on the exterior
of the xture and/or the base of the pole, for
commissioning purposes.
• The MAC address of each node is printed on the
label both as barcode & plain text.
Lightgrid Internal Node Label
Non-Dimmable Fixture: To verify the installation of Lightgrid Internal Node, please follow these steps:
• Apply AC power to the xture (120- 277V, 50/60 Hz)
• If the installation has been done as per instructions in section Wiring, the light will turn o briey during the rst
60 seconds after power is applied.
Dimmable Fixture: To verify the installation of Lightgrid Internal Node, please follow these steps:
• Apply AC power to the xture (120- 277V, 50/60 Hz)
• If the dimming wires are installed as per instructions in section Wiring, the light level will visibly dim within the rst
60 seconds after power is applied and then return to full brightness.
Validation Testing
Labels
RF Antenna Location & Installation
• The selected location of the antenna on the outside of the xture must be free of any signicant conductive
(metal) obstruction horizontally, 360 degrees around it, measured from the base of the antenna where it meets
the lamp xture surface, to at least 12” above this surface. Plastic or glass features will not aect the antenna if
they are at least 1-2cm away from it.
• The preferred location for the antenna on the xture is generally the highest point on the upper surface of the
xture, centered on this mounting surface.
• On hanging xtures supported from above, the antenna may be mounted pointed downward, at a suitable
location on the lower surface of the xture housing.