Installation Guide

Installation Guide
LightGrid Gateway
www.gecurrent.com
© 2021 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are trademarks of the
General Electric Company and are used under license. Information provided is subject to change without
notice. All values are design or typical values when measured under laboratory conditions.
CTRL043 (Rev 11/23/21)
Questions
• Email: [e-mail]
• Leave a Voicemail: 1-877-843-5590
Push the cable through the
sealing gland, and plug it in to
the RJ45 Ethernet jack on the
circuit board.
Slide the split grommet into the
gland, then tighten the sealing
nut to ensure a watertight
seal around the cable. When
tightening the nut, use a wrench
to prevent the gland body from
rotating. Max torque on the
sealing nut: 50 lbs-in.
After following all of the other steps in the primary installation instructions, the customer IT lead
will need to contact the Current IT team to check and troubleshoot any connectivity issues by
emailing [e-mail].
5 6
7
RJ45
Split
grommet