Installation Guide

Installation Guide
LightGrid Gateway
4
USB Cable:
When gateway is used with
an included cellular modem
mounted in the enclosure,
ensure the USB cable to the
modem is securely plugged
in to the USB port on the
gateway circuit board. If the
Gateway is being used with a
wired (Ethernet) connection,
see Appendix B for more
information.
Provide Power and turn ON the
ON/OFF Switch.
Ensure the gateway ON/OFF switch
starts in OFF position. Check that
input power voltage is in the
range 120-277VAC and is 24/7
constant power. Turn on the input
power source, then switch the
gateway ON/OFF switch to the ON
position. Check the indicator light
underneath the Gateway ON/OFF
switch. A solid green light means
the gateway is powered.
Record the Cellular Modem ID numbers.
The ID numbers are found on the sticker on the inside lid of the
enclosure. Take a picture or write down all numbers on the sticker,
and provide these to the Current Support Team for commissioning by
emailing them to [e-mail].
Close the Lid.
To ensure a waterproof
installation, check that no
wires or other objects will be
caught under the rubber seal
on the housing lid. Then close
the lid and lock using the
latch on top. The latch can be
padlocked for added security
(not included).
7
9 10
8
Example photo to send to
Current Support
LED Indicator Turn ON
USB