Installation Guide

Installation Guide
LightGrid Gateway
3
Connect the Coax RF Cable
to the RF Antenna:
The RF Cable is pre-installed
on the gateway assembly.
Attach to the screw terminal
on the bottom of the RF
Antenna, and tighten securely.
Position the magnetic GPS
Antenna on the TOP of the metal
pole mounting bracket.
It must be on the top bracket,facing
upwards, in order to have a clear
view of the open sky.
Connect AC Power Cable:
AC Power cable is not included. Power cable shall be Hard or Junior Hard Service Flexible Cord type, suitable
for use with the Liquid Tight Cable Gland supplied with the box, and should have circular cross section between
Ø0.170” – Ø0.450”/[Ø4.3- Ø11.4mm].
Insert the power feed cable
through the cable gland in the
bottom of the Gateway enclosure.
Strip each wire no more than
0.25”. Route the power cable as
tightly as possible (avoid larger
than necessary loops/slack)
to the terminal block inside
the enclosure. Avoid touching
any other component on the
Gateway circuit board.
Use a wrench to hold the gland
body in place, preventing it
from rotating, and tighten the
sealing nut of the Gland to
ensure a watertight seal to the
cable. Max torque on sealing
nut 50 lbs-in.
Max. torque 50 lbs-in.
Power feed
4 5
6
6a 6b 6c
This radio transmitter (IC: 25008-90002) has been approved by Innovation, Science and Economic Development
Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna
types not included in this list that have a gain greater than the maximum gain indicated for any type listed are
strictly prohibited for use with this device.
Antenna Type Maximum Permissible Antenna Gain (dBi) Required Impedance
Laird FG9023 5 50Ω