User guide
6
The new Sensable software found in the EnviR transmitter allows you to set your known voltage.
The default value shown on the display of 115. If you wish to change it please follow the instructions
below:
1) Follow the steps for pairing the EnviR display and transmitter.
2) When you release the button the screen will show a tuning signal indicating the display is tuning
to the transmitter. When your monitor and transmitter are tuning, the middle right of the display will
show “115”.
3) At this point if you wish to adjust your voltage setting please undertake the following:
(i) Press and hold the recessed tuning button on the transmitter for 3 seconds and then release.
(ii) The display will now have changed and will indicate “120”.
(iii) Repeat this process to select your known voltage (the range is from 100 to 130V starting at
115V).
(iv) Each press cycles the voltage shown on the display, so press as many times as you need to
reach the voltage value you want to use.
(v) For example if you wished to set 130V you will need to repeat steps (i) and (ii) three times
and the display will show 120, 125 and then 130.
4) Once completed, your display will clear and then “0 watts” will appear. This usually takes 1 to 2
minutes. The aerial icon will appear indicating pairing has been successful.
*Please note that the voltage shown on the display is used for the EnviRs internal calculations, this
has nothing to do with the display power adaptor.
The new Sensable software found in the EnviR transmitter allows you to set up additional C
2
enabled
displays within the home. To pair additional displays please undertake the following steps:
1) Place the transmitter and display in the same room.
2) Using a ballpoint pen or similar, push and hold the recessed tuning button, found in the front-centre
of the black transmitter, until the LED on the transmitter has ashed exactly
3) Upon releasing, the red LED on the transmitter will rapidly ash for a minute, indicating that the
transmitter is now ready to pair with any additional C
2
enabled displays, at the same time as staying
paired with the existing EnviR display. If it doesn’t, please try again.
4) Whilst the LED on the transmitter is ashing, at the additional display(s) press and hold the DOWN
(V) button on the display until the LED on the display ashes.
5) When you release the button on the additional display(s) the screen will show a tuning signal
indicating the display(s) is tuning to the transmitter.
6) Once tuning is completed, all displays will clear and then “0 watts” will appear. This usually takes 1
to 2 minutes. The aerial icon will appear indicating pairing has been successful.
EnviR - The SmartR Monitor
PowerSave Envi R Man.indd 6 04/11/2011 14:47