Installation guide

8
Limited One Year Warranty
PowerSave Inc. warrants this product for a period of one (1) year from date of purchase for all defects in workmanship or
materials to the original user or consumer purchaser. This warranty excludes and does not cover defects, malfunctions, or
failures caused by misuse, unauthorized repairs, modications or accidental damage. All defective parts will be repaired free
of charge or replaced.
Note: This warranty does not apply to batteries. This warranty is only applicable to a product purchased through a PowerSave
Inc. authorized Reseller. In no event shall PowerSave, Inc. be liable for consequential or incidental damages. This warranty is
in lieu of all other expressed warranties. The duration of any implied warranty is limited to the period of the expressed warranty
set forth above.
Specifications
NOTE: The display format is not suitable for accuracy checking of utility supplied electric meter.
Specifications
Product Size: 9.3cm x 12cm (base) x 15.5 cm
Viewable Screen: 7.3cm x 9cm
Retail Package Size: 35cm x 17cm x 5.5cm
Internal Power Requirement: Mains block adapter (nominal 1.0 watt)
Display power supply UL listed.
Physical Format: Table-top
Energy Monitored: Electricity (gas, LPG, oil in development)
Receiver: 433MHz SRD band
Communication Platform: C2 architecture
Sensor Coding Recognition: 10 channel (each three input potential)
Recognition Method: User Initiated - seeks 4,096 possibilities
Number of Permitted Sensors: Ten (x3 input)
Display: Liquid Crystal segmented display
Backlight: No
LCD mode: Positive reective -12:00 view
Main services: Energy, Kwh and Dollars
Subordinate Services: Clock time (24hr), room temperature WT
24 hour rolling consumption (bar graph) display (social division into 3 x 8hr periods)
PC connection for streaming data for seven years historical data.
Software code: starting Vx.09
Tariff pre-set at prevailing rate (issued by the purchaser). Adjustable to $99.9
Manufactured in China for Current Cost Ltd. North American Master Distributor: PowerSave, Inc.
CE Approvals:
ETSI EN 300 220-2 V2.1.1(2006-04), EN 50371 2002, EN 301489-3 v1.4.1 2002-08, EN
60215:1989+A1:1992+A2:1994, IEC 60950-1:2001(1st Edition) and/or EN 60950-1:2001+A11:2004
For more information please visit www.powersave.us
email: [e-mail] or call: 1(888) 636-0444
PowerSave, Inc. Plantation, Florida
Version EIG2.1 ©PowerSave,Inc. All Right reserved
(1) 15.105 statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.