User guide

6 7
Setting up your EnviR – CT Jaw Monitor
Setting up your EnviR display
1) The display power adapter should be connected to the round socket found in the
base of the display unit.
2) Plug the display power adapter into a convenient wall socket.
3) The ‘Energy Now’ value on the display will now show dashes. The EnviR energy monitor
should be left powered on at all times to read energy correctly and run its clock.
4) Remove the plastic battery tab from the back of the black transmitter unit; the transmitter
will now be activated.
5) If the display shows ‘0 Watts’ the display has already been paired and is ready to use. If it
shows dashes the display and transmitter need pairing. It is good practice to uniquely pair
your display to avoid cross communication with a neighbours monitor.
Pairing the EnviR display and transmitter
1) Place the transmitter and the display in the same room.
2) On the front locate the recessed tuning button in the centre of the transmitter.
3) Using a used match, pen or similar, push and hold the recessed tuning button or until the
LED on the transmitter has ashed ONCE only.
4) Upon releasing, the red LED on the transmitter will rapidly ash for a minute. If it doesn’t,
please try again.
5) Whilst the LED on the transmitter is ashing, press and hold the DOWN
button on the
display until the LED on the display ashes.
6) When you release the button, the screen will show a tuning signal indicating the display is
tuning to the transmitter. When your monitor and transmitter are tuned, the middle right of the display
will show ‘240’ (indicating UK domestic voltage).
7) Once the process is completed, your display will clear and then ‘0 watts’ will appear. This
usually takes 1 to 2 minutes. The aerial icon will appear indicating pairing has been successful.
Meter
MAINS SUPPLY
TO HOUSE VIA FUSE BOX
/SWITCHBOARD
0 0 0 3 5 2 5 2
Button
1
OPTION
Sensor Type
The Current Cost EnviR now comes with a choice of 2 sensor types:
1
CT Jaw
Adapter
For installation instructions please
refer to pages 7 - 10 and then 13 - 16
How it works:
The EnviR monitor shows real time information;
a wireless signal is sent every six seconds from
a transmitter attached via a CT jaw to your
meter and then to the display. This enables
you to view your energy consumption easily,
showing changes in power consumption when
different electrical appliances are used.
Contents of your box
• EnviR Display
• S² transmitter with CT Jaw
• Power Adapter for Display
• Instruction manual
• 1 year Warranty (option to extend online)
How it works
The EnviR monitor shows real time information;
a wireless signal is sent every six seconds from
a transmitter attached via an optical reader
to your meter and then to the display. This
enables you to view your energy consumption
with 100% accuracy, easily showing changes in
power consumption when different appliances
are used.
Contents of your box
• EnviR Display
• C² White OptiSmart transmitter
• OptiSmart Reader
• Power Adapter for Display
• Instruction manual
• 1 year Warranty (option to extend online)
For installation instructions please
refer to pages 11 - 16
OptiSmart Reader
2
Adapter