Specifications

12-2008 2. Introduction
4. Install the wheel and axle assembly (axle assembly and wheel assemblies).
a. Remove the rubber pads secured to the frame where the axle is attached.
b. Remove the cotter pins and loose washers from the axle assembly (axle, two loose
washers, two cotter pins, and fasteners).
c. Install the wheels (flat free tire and wheel); make sure the long hub is to the inside.
d. Reinstall the washers and cotter pins on the axle assembly. Bend one leg of each
cotter pin.
e. Place the axle assembly under the cross member as shown and install four bolts and
nuts. Tighten securely.
No. Description No. Description
1 Frame 4 Support Leg Assembly
2 Wheel Assembly 5 Wooden Blocks
3 Axle Assembly 6 Handle Assembly
FIGURE 6. INSTALLED WHEEL KIT
914-0103 (Issue 3) 11