Specifications
2.5 Assembly Instructions
WARNING: The generator set is heavy. Dropping the generator set can cause severe
CAUTION: Too little oil can cause severe engine damage. Make sure that the oil level is above
CAUTION: Methanol is corrosive to fuel system components. Do not use gasoline or gasoline
2.6 Wheel Kit Assembly Instructions
CAUTION: Improper handling of the generator set can result in equipment damage. Do not
2. Introduction 12-2008
1. Remove the generator set from the box.
personal injury or death. Keep feet and hands clear when lifting the generator
set.
2. If necessary, install the wheel kit (see the Wheel Kit Assembly Instructions).
3. Add oil to the generator set.
the Add mark on the dipstick.
4. Add gasoline to the fuel tank.
additives containing methanol.
The use of leaded gasoline will require extra maintenance. Avoid using leaded
gasoline.
5. If necessary, install the battery. A 12 volt, 14L-A2 type battery is recommended. The
battery is not included with the generator set. The battery cables are often tucked up
behind the control panel. Connect the positive (+) cable (red) first and then the negative ( – )
cable (green).
turn the generator set on the side, top, or end. Doing so may damage the
generator set or cause dangerous fuel or oil leakage. Do not place items on top of
the generator set. The wheel kit is designed to support the generator only.
Required Tools
· 10 and 12 mm wrenches, sockets, and ratchet
· Three 6-inch high blocks of wood
· Pliers
Installation Procedure
1. Install the handle assembly (handle, bracket, hinge pin, grips, end plugs, two cotter pins,
and fasteners).
a. Use two long bolts to attach the handle assembly to the frame.
b. Tighten securely; do not crush the frame tube.
2. Block up the generator set under both frame tubes as shown below. Place a block under
the center of the cross-member on the exhaust end.
3. Install the leg assembly.
a. Install a leg assembly (support leg, rubber pad, and fastener) onto each side of the
exhaust end cross-member.
b. Use two bolts and nuts for each leg and tighten securely.
10 914-0103 (Issue 3)