Installation manual

7 Operation
7.1 3 Position Switch
A three-position Start/Stop switch is located at the genset control panel.
Switch positions available:
· Manual Start: Normally only the maintenance/service technician has occasion to manually
start and stop the generator set. Push the switch down at the thick end to start the set
immediately.
· Stop (middle position): This switch disables the set.
· Remote: For automatic operation, the Start/Stop switch must be in the Remote position
and Standby On must be activated on the In-Home Display. Push the switch down at the
thin end to put into the Remote position.
No. Description No. Description
1 Manual Start Position 2 Remote Position
3 Stop Position
FIGURE 39. 3 POSITION SWITCH (STOP SWITCH)
A029V088 (Issue 2) 51