Installation manual

6. Optional Internet/Email Interface Setup 4-2010
FIGURE 28. NETWORK CONNECTIONS
6.2 In-Home Network Access to the Generator Set
1. Connect an Ethernet cable from the generator set control board to a router that has enough
ports to connect the generator set and a computer.
2. Write down the IP Address (shown on the Network Setup screen below) on the generator
set's in-home operator panel.
NOTE: Leave the DHCP ON.
3. Type the generator set IP Address in the address bar of the web browser of a computer
established on the same in-home network as the generator set.
4. Enter the default User Name and Password.
User Name: Admin
42 A029V088 (Issue 2)