Installation manual

4-2010 3. Step-By-Step Outline of Installation
An optional thermostatically controlled battery heater is available for more reliable starting in
ambient temperatures down to -20 °F (-28.8 °C). The heater wraps around the battery. The
heater cord is connected to the 120V, accessory junction box. Install the heater in accordance
with the kit instructions.
To prevent injury due to accidental start-up, do not connect the battery cables to the battery until
the installation has been completed and it is time to start the set.
WARNING: Before working on the generator set, move the Switch (S2) to the Stop
Position, disconnect the remote harness (P7) to disable the ATS mounted
charger, and remove the negative (-) battery cable from the battery to prevent
starting.
FIGURE 11. BATTERY INSTALLATION
3.7 Fuel System
WARNING: Fuel systems must be installed by qualified service technicians. Improper
installation presents hazards of fire and improper operation, resulting in
severe personal injury or property damage.
This generator set has a convertible fuel system. The generator may run on Natural Gas or
Propane, depending on the preferences of the owner.
WARNING: Gaseous fuels are flammable, explosive and can cause severe personal
injury or death. Do not smoke if you smell gas, are near fuel tanks for
fuel-burning equipment or are in an area sharing ventilation with such
equipment. Keep flames, sparks, pilot lights, electrical arcs, arc-producing
equipment and all other sources of ignition well away. Keep a type ABC fire
extinguisher handy.
A029V088 (Issue 2) 25