Specifications
4. Maintenance 9-2010
5. Refill with 67 oz (2 liters) of oil.
CAUTION: Too much oil can cause high oil consumption. Too little oil can cause severe
engine damage. Keep the oil level between the Full and Add marks.
6. Start and run for 30 seconds.
7. Shut the engine off and wait 30 seconds.
8. Add more oil slowly, to bring the oil level to the FULL mark on the dipstick.
9. Dispose of the used oil and oil filter according to local environmental regulations.
4.5 Replacing the Air Filter Element
WARNING: Before working on the generator set, move the Switch (S2) to the Stop
Position, disconnect the remote harness (P7) to disable the ATS mounted
charger, and remove the negative (-) battery cable from the battery to prevent
starting.
Refer to the Periodic Maintenance Table for scheduled air filter replacements. Replace it more
often in dusty environments.
To change the filter element:
1. Remove the outer and inner cover and reassemble with a new air filter element.
2. Make sure the outer cover is seated before tightening its wing nut.
34 A029V089 (Issue 3)










