Product Manual A

6. Startup and Configuration PCC 2.37-2018

NOTICE

The number of starting cycles, and the crank and rest times are set from

within the Setup menu. Trained and experienced service personnel are

required to change the default setting. Contact your authorized Cummins

distributor.

Initial Pre-Start Checks

WARNING

Electric Shock Hazard

Voltages and currents present an electrical shock hazard that can cause

severe burns or death.

Make sure that only personnel who are trained and experienced work with

distribution voltages. Even after generator set shutdown, an electrical shock

hazard may still exist, caused by induced or residual voltage within the

alternator or cables. Some interfaces may display zero voltage even when

voltages are present.

WARNING

Hot Pressurized Liquid

Contact with hot liquid can cause severe burns.

Do not open the pressure cap while the engine is running. Let the engine

cool down before removing the cap. Turn the cap slowly and do not open it

fully until the pressure has been relieved.

Before starting, competent personnel must make the following checks to make sure

that the unit is ready for operation: