Product Manual B
3. Control System 3-2018
46 A051X877 (Issue 7)Copyright © 2018 Cummins Inc.
Selecting Auto Mode
WARNING
Electrical Generating Equipment
When changing modes, the generator set can start or stop without warning
(for example, Auto Mode may have been selected with no mains (utility)
power available).
Make sure there is no danger to personnel or equipment, if the generator set
starts or stops when changing modes.
To switch to Auto mode (see Figure 15 on page 47),
1. Ensure that it is safe to do so before proceeding to change the mode.
2. Press the Auto button on any of the Operator menus, or the
‘Establishing/Re-establishing communication with control’ menus.
3. If the mode change access code feature is enabled, the Mode Change Access
Code menu is displayed. Enter the Mode Change Access Code.
4. A menu with alternating arrows will then be displayed above a second
Auto symbol.
5. Press this second Auto button. The Operator menu that was displayed
before Auto mode was selected is re-displayed, but with the Auto symbols
blacked out and Manual Run symbols visible.
To disable Auto mode, press the Off button.
The generator set is now ready to receive a remote start signal that will initiate the
Auto run mode.
WARNING
Should a remote start signal be received, the generator set starts
automatically. Make sure there is no danger to personnel or equipment
should the generator set start without warning.
NOTICE
Manual Run mode can also be selected FROM Auto mode. Switching to
Manual Run mode results in the generator set starting up.