Product Manual B
Table Of Contents
- Table of Contents
- 1. IMPORTANT SAFETY INSTRUCTIONS
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 Generator Set Safety Code
- 1.4 Moving Parts Can Cause Severe Personal Injury or Death
- 1.5 Electrical Shocks and Arc Flashes Can Cause Severe Personal Injury or Death
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Exhaust Gases Are Deadly
- 1.9 The Hazards of Carbon Monoxide
- 1.10 Earth Ground Connection
- 2. Introduction
- 3. Control System
- 4. Operation
- 5. Maintenance
- 6. Troubleshooting
3. Control System7-2018
49A045R242 (Issue 12) Copyright © 2018 Cummins Inc.
Selecting Off Mode
WARNING
Electrical Generating Equipment
When changing modes, the generator set can start or stop without warning
(for example, Auto Mode may have been selected with no mains (utility)
power available).
Make sure there is no danger to personnel or equipment, if the generator set
starts or stops when changing modes.
To switch to Off mode (see the figure below),
1. Make sure that it is safe to do so before proceeding to stop the set.
2. Press the Off button on any of the Operator menus or the "Establishing/Re-
establishing communication with control" menus.
3. If the Mode Change Access Code is enabled, the Mode Change Access Code
will be displayed. Enter the Mode Change Access Code.
4. On entering the last correct digit, the basic screen will re-appear, and the set
will stop without a Time Delay to Stop.
NOTICE
Make sure that there is no danger to personnel or equipment if the
generator set is stopped.