Product Manual B
Table Of Contents
- Table of Contents
- 1. IMPORTANT SAFETY INSTRUCTIONS
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 Generator Set Safety Code
- 1.4 Moving Parts Can Cause Severe Personal Injury or Death
- 1.5 Electrical Shocks and Arc Flashes Can Cause Severe Personal Injury or Death
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Exhaust Gases Are Deadly
- 1.9 The Hazards of Carbon Monoxide
- 1.10 Earth Ground Connection
- 2. Introduction
- 3. Control System
- 4. Operation
- 5. Maintenance
- 6. Troubleshooting
5. Maintenance 7-2018
74 A045R242 (Issue 12)Copyright © 2018 Cummins Inc.
Maintenance Item
Daily
or After
24 Hours
Weekly
or After
50 Hours
100
Hours
1 Year
or After
200 Hours
1
2
Years
1
4000
Hours
Check electrical
connections
(battery, starter
motor, alternator
connections).
Check for tight
connections,
general condition
and remove any
corrosion.
■
Check alternator
heater (where
fitted). Check
general condition
and wiring
connections.
■
Check battery
heater (where
fitted). Check
general condition
and wiring
connections.
■
Replace cooling
system coolant.
■
Inspect all sealed
bearings every
4000 to 4500
hours
■
4
1
To be performed by a qualified Service Technician.
2
After the initial 50 hour interval and every 200 hours thereafter.
3
Cleaning schedule may be reduced depending on operating conditions/environment.
4
Replace all bearings every 30000 hours or 5 years (or if necessary after 10000 hours or 2
years).
Maintenance Record
Record all periodic and unscheduled maintenance and service. See the Periodic
Maintenance Schedule for a list of scheduled maintenance frequency.