Product Manual

3. Installation8-2018

NOTICE

Service entrance (SE) model transfer switches are rated service entrance equipment. The main

bonding jumper is factory installed in the connected position between the Neutral assembly and

Ground stud on the cabinet. By installing a transfer switch as shown in the figure below, the

main bonding jumper should be removed or moved from a connected position to a disconnected

position

No. Description No. Description

1 Utility Source 6 Circuit Breaker

2 Utility Panel 7 Generator Source

3 Loads 8 Loads

4 Circuit Breaker 9 Distribution Panel

5 Transfer Switch

FIGURE 15. PARTIAL COVERAGE SYSTEM (SERVICE ENTRANCE MODEL)