Quick Start Guide
Table Of Contents
- SAFETY PRECAUTIONS
- PRE-START CHECKLIST
- SELECTING AN OPERATING MODE
- SETTING THE REMOTE AND STANDBY MODES
- BASIC SEQUENCE OF OPERATION
- EXERCISING THE GENERATOR SET
- Note: Crank exercise is enabled as a default. During every other exercise cycle the generator will not start. See the Operator manual to disable.
- MANUAL STARTING AND STOPPING
- LOADING THE GENERATOR SET
- OPERATING IN COLD WEATHER
- OPERATING IN DUSTY ENVIRONMENTS
- CONDUCTING GENERAL INSPECTIONS
- PERIODIC MAINTENANCE SCHEDULE TABLE
- TYPICAL GENERATOR SET
A062M461 (Issue 2) 7-2019 Page 2 of 4 Copyright © 2019 Cummins Inc.
MANUAL STARTING AND STOPPING
Action
Manual Start (Local Display)
Manual Start (Remote Display)
Start
1. From the Main screen, select the START key.
2. A second screen appears notifying the operator that Standby will be
disabled. Select the START key again to start the generator set.
3. After the generator set reaches rated voltage and frequency, the
transfer switch transfers the building load to the generator set. The
building's electrical power is now provided by the generator set.
Remote mode must be enabled on the
local display to allow manual start and
stop from the Remote display. The
manual start and stop sequences are the
same for the Remote display and the
Local display.
Stop
Press the red STOP button on the local display. The generator set will
stop immediately and the building load will be transferred to the utility.
Note: For normal operation to resume, Standby mode will need to be
enabled.
Note: Press the generator set's red STOP button on the local display to stop the generator set, which will disable both Remote and
Standby Modes.
OPTIONAL REMOTE MONITORING SYSTEM (RMS) ACCOUNT SETUP AND GENERATOR SET CONTROL CONNECTION
1. Prior to setting up the new customer account, make sure that the generator set control is connected to the Internet via an
Ethernet cable between the generator set control and the home’s router.
2. To access the generator set control, open the generator cover and remove the right side control access panel.
3. Route the Ethernet cable into the generator set through the right side of the enclosure. Then route and secure the Ethernet
cable above the intake manifold along with the other customer wiring connections.
Ethernet Cable Routing
Ethernet Port on Generator Control
4. The Ethernet cable needs to be rated for 300V if it is routed through the same conduit as the AC load cables.
5. From a computer device, access the Cummins ConnectCloud website by navigating to https://connectcloud.cummins.com
.
6. Click on the Register button to start the registration process.
7. Follow the on-screen prompts to register your account and add your generator.
Note: Cummins Connect Cloud Android and iPhone cellular apps are also available.