Product Manual
Table Of Contents
- Table of Contents
- 1. IMPORTANT SAFETY INSTRUCTIONS
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 Generator Set Safety Code
- 1.4 Moving Parts Can Cause Severe Personal Injury or Death
- 1.5 Electrical Shocks and Arc Flashes Can Cause Severe Personal Injury or Death
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Exhaust Gases Are Deadly
- 1.9 The Hazards of Carbon Monoxide
- 1.10 Earth Ground Connection
- 2. Introduction
- 3. Control System
- 4. Operation
- 5. Maintenance
- 6. Troubleshooting
4. Operation 8-2019
58 A062J680 (Issue 2)Copyright © 2019 Cummins Inc.
If a generator set fault occurs that will stop the generator set, the red FAULT light
illuminates and a Fault message appears. The screen shows the Fault Code (FC)
number, a brief description of the fault, current engine hours and the time and date
of the fault.
FIGURE 28. TYPICAL FAULT SCREEN
Press the BACK button to reset the fault and return to the home screen. The red
FAULT light will shut off.
See the "Fault Log" Screen section of this manual for instructions on viewing the log
of the last 20 faults.
“NEW EVENT” SCREEN
A New Event screen appears whenever the system status changes. The screen
provides a brief description of the event, the current engine hours, and the date and
time of the event. The message remains displayed unless superseded by a new
event, or the BACK button is pressed.
1. Operation Events:
FIGURE 29. MANUAL STOP – STANDBY DISABLED
FIGURE 30. STANDBY ENABLED