Product Manual
Table Of Contents
- Table of Contents
- 1. IMPORTANT SAFETY INSTRUCTIONS
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 Generator Set Safety Code
- 1.4 Moving Parts Can Cause Severe Personal Injury or Death
- 1.5 Electrical Shocks and Arc Flashes Can Cause Severe Personal Injury or Death
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Exhaust Gases Are Deadly
- 1.9 The Hazards of Carbon Monoxide
- 1.10 Earth Ground Connection
- 2. Introduction
- 3. Control System
- 4. Operation
- 5. Maintenance
- 6. Troubleshooting
4. Operation8-2019
55A062J680 (Issue 2) Copyright © 2019 Cummins Inc.
FIGURE 24. EXERCISING
c. When the defined exercise time has completed, the generator set
stops and normal operation resumes.
FIGURE 25. EXERCISE CYCLE COMPLETED
2. Crank Only Exercise Sequence
NOTICE
Standby Mode must be enabled for Crank Exercise to execute.
When Crank Exercise is enabled, the generator set will alternate between
crank only exercise and standard (that is, generator set running) exercise
sequences.
The following steps will be executed when the programmed exercise day
and time are reached or the Exercise Now option is selected and the
crank only exercise sequence is run:
a. The generator set engine starter engages and rotates the engine, but
the engine does not start.