Product Manual
Table Of Contents
- Table of Contents
- 1. IMPORTANT SAFETY INSTRUCTIONS
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 Generator Set Safety Code
- 1.4 Moving Parts Can Cause Severe Personal Injury or Death
- 1.5 Electrical Shocks and Arc Flashes Can Cause Severe Personal Injury or Death
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Exhaust Gases Are Deadly
- 1.9 The Hazards of Carbon Monoxide
- 1.10 Earth Ground Connection
- 2. Introduction
- 3. Control System
- 4. Operation
- 5. Maintenance
- 6. Troubleshooting
3. Control System8-2019
37A062J680 (Issue 2) Copyright © 2019 Cummins Inc.
FIGURE 9. MODE SETUP SCREEN (LOCAL DISPLAY)
2. To enable or disable the Standby mode on the REMOTE display:
NOTICE
Remote must be enabled before Standby mode can be changed from the
Remote display. If Remote mode is not enabled, Standby will remain
disabled and cannot be changed.
a. From any screen, select the Mode key to get to the Mode screen.
b. Use the arrow keys to enable or disable the Standby mode.
c. Keep pressing the Back button to save the settings and return to the Main
screen.
FIGURE 10. MODE SETUP SCREEN (REMOTE DISPLAY)