Product Manual
Table Of Contents
- Table of Contents
- 1. IMPORTANT SAFETY INSTRUCTIONS
- 1.1 Warning, Caution, and Note Styles Used in This Manual
- 1.2 General Information
- 1.3 Generator Set Safety Code
- 1.4 Moving Parts Can Cause Severe Personal Injury or Death
- 1.5 Electrical Shocks and Arc Flashes Can Cause Severe Personal Injury or Death
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Exhaust Gases Are Deadly
- 1.9 The Hazards of Carbon Monoxide
- 1.10 Earth Ground Connection
- 2. Introduction
- 3. Control System
- 4. Operation
- 5. Maintenance
- 6. Troubleshooting
23A062J680 (Issue 2) Copyright © 2019 Cummins Inc.
3 Control System
3.1 System Setup
"Establishing Communications" Message
NOTICE
Once the battery is connected to the generator set and any display button is
pressed, the local display shows an "establishing communications"
message for approximately 5 seconds. (This may take longer if the signal
integrity is poor between the control and display due to a bad wire or
Electro-Magnetic Interference [EMI].) Once communication is established,
the display shows the HOME screen.
The “establishing communications” message will also be displayed
whenever the control is brought out of “sleep” mode by pressing any button
on the display. Sleep mode is entered after 30 minutes without utility or
generator set power to preserve battery energy since the battery charger will
not have AC power. The 30-minute timer is reset with any button press on
the display.
Operating the Generator Set Cover Safely
To configure the local display or access the generator set, you will need to lift the
cover (lid). The cover of the generator set is designed to latch securely into the "up"
position to prevent accidental closure.
• To open: Lift the cover until the hinge pin drops into the hinge pin slot. Test
that the cover is secure by gently pressing down on the cover.
• To close: Lift up on the cover while pressing upward on the hinge pin and slide
the pin upwards out of the hinge pin slot. Carefully push the cover downward
and let go of the hinge pin allowing it to ride along the hinge until the cover is
closed.