Install Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Save These Instructions
- 1.2 General Information
- 1.3 General Precautions
- 1.4 Generator Set Voltage Is Deadly
- 1.5 Engine Exhaust Is Deadly
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Starting Batteries
- 1.9 Moving Parts Can Cause Severe Personal Injury or Death
- 1.10 The Hazards of Carbon Monoxide
- 2. Introduction
- 3. Pre-Installation Considerations
- 4. Installation
- 5. Startup and Configuration
- 5.1 "Establishing Communications" Message
- 5.2 "Clock Setup" Screen
- 5.3 "Exercise" Screen
- 5.4 "Brightness and Contrast" Screen
- 5.5 "About" Screen
- 5.6 "Event Log" Screen
- 5.7 "Fault Log" Screen
- 5.8 "System Status" Screen
- 5.9 "Mode" Screen
- 5.10 Automatic Load Management
- 5.11 Manual Start Sequence (Local)
- 5.12 Checklist
- 5.13 Startup
- 6. Remote Monitoring System (RMS) Description
- Appendix A. Fuel Line Selection
- Appendix B. Outline and System Drawings
- Appendix C. Wiring Diagrams
6. Remote Monitoring System (RMS) Description 8-2019
78 A062J678 (Issue 2)Copyright © 2019 Cummins Inc.
NOTICE
The following Internet browsers are compatible with this option:
• Microsoft Internet Explorer
®
(version 9 or greater)
• Apple Safari
®
• Google Chrome™
• Mozilla Firefox
®
(version 3.6 or greater)
• Microsoft
®
Edge
6.2 RMS Customer Account Setup and Generator
Set Control Connection
The following instructions for setting up an account and the generator set control
connection are for customers only.
1. Prior to setting up the new customer account, make sure that the generator set
control is connected to the Internet via an Ethernet cable between the generator
set control and your home router.
2. To access the generator set control, open the generator cover and remove the
right side control access panel.
3. Route the ethernet cable into the generator set through the right side of the
enclosure. Then route and secure the ethernet cable above the intake manifold
along with the other customer wiring connections.
4. Ensure the ethernet cable is securely inserted into the generator set control.