Install Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Save These Instructions
- 1.2 General Information
- 1.3 General Precautions
- 1.4 Generator Set Voltage Is Deadly
- 1.5 Engine Exhaust Is Deadly
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Starting Batteries
- 1.9 Moving Parts Can Cause Severe Personal Injury or Death
- 1.10 The Hazards of Carbon Monoxide
- 2. Introduction
- 3. Pre-Installation Considerations
- 4. Installation
- 5. Startup and Configuration
- 5.1 "Establishing Communications" Message
- 5.2 "Clock Setup" Screen
- 5.3 "Exercise" Screen
- 5.4 "Brightness and Contrast" Screen
- 5.5 "About" Screen
- 5.6 "Event Log" Screen
- 5.7 "Fault Log" Screen
- 5.8 "System Status" Screen
- 5.9 "Mode" Screen
- 5.10 Automatic Load Management
- 5.11 Manual Start Sequence (Local)
- 5.12 Checklist
- 5.13 Startup
- 6. Remote Monitoring System (RMS) Description
- Appendix A. Fuel Line Selection
- Appendix B. Outline and System Drawings
- Appendix C. Wiring Diagrams
4. Installation8-2019
29A062J678 (Issue 2) Copyright © 2019 Cummins Inc.
No. Description No. Description
1 Spacer Length (2.18 in [55.4 mm]) 2 Spacer Through-Hole Diameter (0.59
in)
FIGURE 5. MOUNTING SPACER
2. Prefabricated pad only: Install the bolts with the washer under the head through
the spacer and into the prefabricated pad and tighten. Torque value: 37 ft-lb (50
Nm).
3. Poured slab only:
a. Mark the location for the anchor bolts with the generator set in place.
b. Install the anchor bolts per the manufacturer's recommendation for both
embedment and tightening torque.
NOTICE
There are several styles of anchor bolts available. Follow the anchor
bolt manufacturer's requirements for hole size and depth. The length of
the anchor bolt must accommodate:
• The embedment length of the bolt into the pad
• The length of the spacer
• The thickness of the washer and
• The thickness of the nut (if used)
4. Install the chassis plugs in the generator set's lifting holes after the unit is in its
final position.