Install Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Save These Instructions
- 1.2 General Information
- 1.3 General Precautions
- 1.4 Generator Set Voltage Is Deadly
- 1.5 Engine Exhaust Is Deadly
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Starting Batteries
- 1.9 Moving Parts Can Cause Severe Personal Injury or Death
- 1.10 The Hazards of Carbon Monoxide
- 2. Introduction
- 3. Pre-Installation Considerations
- 4. Installation
- 5. Startup and Configuration
- 5.1 "Establishing Communications" Message
- 5.2 "Clock Setup" Screen
- 5.3 "Exercise" Screen
- 5.4 "Brightness and Contrast" Screen
- 5.5 "About" Screen
- 5.6 "Event Log" Screen
- 5.7 "Fault Log" Screen
- 5.8 "System Status" Screen
- 5.9 "Mode" Screen
- 5.10 Automatic Load Management
- 5.11 Manual Start Sequence (Local)
- 5.12 Checklist
- 5.13 Startup
- 6. Remote Monitoring System (RMS) Description
- Appendix A. Fuel Line Selection
- Appendix B. Outline and System Drawings
- Appendix C. Wiring Diagrams
3. Pre-Installation Considerations 8-2019
24 A062J678 (Issue 2)Copyright © 2019 Cummins Inc.
FIGURE 4. TRANSFER SWITCH CONNECTIONS FOR FULL COVERAGE LOAD
Loose Parts Shipped with the Generator Set
The following loose parts are shipped with the generator set:
• Two enclosure keys
• Generator set mounting spacers
• Circuit breaker cover and screw
• Chassis plugs
• Transfer switch TB4 jumper
NOTICE
This jumper must be installed in the RA series transfer switch according
to the interconnect diagram in the RA series transfer switch owner
manual.
• Literature (Operator Manual, Quick Start Operator Guide, Installation Manual,
Quick Start Installation Guide, Health and Safety Manual, and Warranty
Statements)