Install Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Save These Instructions
- 1.2 General Information
- 1.3 General Precautions
- 1.4 Generator Set Voltage Is Deadly
- 1.5 Engine Exhaust Is Deadly
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Starting Batteries
- 1.9 Moving Parts Can Cause Severe Personal Injury or Death
- 1.10 The Hazards of Carbon Monoxide
- 2. Introduction
- 3. Pre-Installation Considerations
- 4. Installation
- 5. Startup and Configuration
- 5.1 "Establishing Communications" Message
- 5.2 "Clock Setup" Screen
- 5.3 "Exercise" Screen
- 5.4 "Brightness and Contrast" Screen
- 5.5 "About" Screen
- 5.6 "Event Log" Screen
- 5.7 "Fault Log" Screen
- 5.8 "System Status" Screen
- 5.9 "Mode" Screen
- 5.10 Automatic Load Management
- 5.11 Manual Start Sequence (Local)
- 5.12 Checklist
- 5.13 Startup
- 6. Remote Monitoring System (RMS) Description
- Appendix A. Fuel Line Selection
- Appendix B. Outline and System Drawings
- Appendix C. Wiring Diagrams
6. Remote Monitoring System (RMS) Description8-2019
81A062J678 (Issue 2) Copyright © 2019 Cummins Inc.
11. Enter your email address. Click the Send Verification Code button.
12. Check your email for the verification code and enter it in the Verification code
field.
13. Click the Verify Code button.
14. Create a new password.
15. Enter your first name and last name.
16. Click on the Create button.
17. Complete the required (*) fields on the Setup New Generator page:
a. Enter the contact information for the location.
b. Enter the Serial Number and Customer Access Code:
i. Find the Serial Number and Customer Access Code on the generator
set's control display by pressing Menu => Next => About => Next.
The About Genset screen will appear on the display.
c. Click on the "I'm not a robot" box and follow the directions.
d. Click on the Continue button.
If your generator set has an active Internet/cloud connection and your serial
number and customer access code are correct, and the generator set is not
already linked to another account, a message will appear on the screen that
says, "Your device has been located".
NOTICE
Communications on the network must be open to 168.61.54.255 on port
8884 and 40.114.00.153 on port 8885.
18. Optional: Link your account to your local dealer. If you do not see your dealer in
the list, it is possible the dealer has not yet registered themselves as a dealer
on the Cummins Connect Cloud; in this case, contact the dealer.
NOTICE
You can add or change your dealer at any time.
19. Optional: After you have registered and accessed your home page, add
additional users or generator sets to your account by navigating to Preferences,
My Generators, or Manage Users.
NOTICE
Android and iPhone applications for the Cummins ConnectCloud are also
available. Using a mobile application will enable you to receive status and
warning notifications.