Install Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Save These Instructions
- 1.2 General Information
- 1.3 General Precautions
- 1.4 Generator Set Voltage Is Deadly
- 1.5 Engine Exhaust Is Deadly
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Starting Batteries
- 1.9 Moving Parts Can Cause Severe Personal Injury or Death
- 1.10 The Hazards of Carbon Monoxide
- 2. Introduction
- 3. Pre-Installation Considerations
- 4. Installation
- 5. Startup and Configuration
- 5.1 "Establishing Communications" Message
- 5.2 "Clock Setup" Screen
- 5.3 "Exercise" Screen
- 5.4 "Brightness and Contrast" Screen
- 5.5 "About" Screen
- 5.6 "Event Log" Screen
- 5.7 "Fault Log" Screen
- 5.8 "System Status" Screen
- 5.9 "Mode" Screen
- 5.10 Automatic Load Management
- 5.11 Manual Start Sequence (Local)
- 5.12 Checklist
- 5.13 Startup
- 6. Remote Monitoring System (RMS) Description
- Appendix A. Fuel Line Selection
- Appendix B. Outline and System Drawings
- Appendix C. Wiring Diagrams
6. Remote Monitoring System (RMS) Description 8-2019
80 A062J678 (Issue 2)Copyright © 2019 Cummins Inc.
FIGURE 36. ETHERNET PORT ON GENERATOR CONTROL
5. The ethernet cable needs to be rated for 300V if it is routed through the same
conduit as the AC load cables.
6. From the control, verify that your generator set has cloud connectivity on the
Cloud Info screen on the display by pressing Menu => Next => About => Next
=> Next.
7. From a computer device, access the Cummins ConnectCloud website by
navigating to https://connectcloud.cummins.com/.
8. Click on the Register button to start the registration process.
9. Agree to the terms of service by scrolling down to the bottom of the page and
checking the box next to "I have read and accept the terms of service".
10. Click on the Accept button.