Install Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Save These Instructions
- 1.2 General Information
- 1.3 General Precautions
- 1.4 Generator Set Voltage Is Deadly
- 1.5 Engine Exhaust Is Deadly
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Starting Batteries
- 1.9 Moving Parts Can Cause Severe Personal Injury or Death
- 1.10 The Hazards of Carbon Monoxide
- 2. Introduction
- 3. Pre-Installation Considerations
- 4. Installation
- 5. Startup and Configuration
- 5.1 "Establishing Communications" Message
- 5.2 "Clock Setup" Screen
- 5.3 "Exercise" Screen
- 5.4 "Brightness and Contrast" Screen
- 5.5 "About" Screen
- 5.6 "Event Log" Screen
- 5.7 "Fault Log" Screen
- 5.8 "System Status" Screen
- 5.9 "Mode" Screen
- 5.10 Automatic Load Management
- 5.11 Manual Start Sequence (Local)
- 5.12 Checklist
- 5.13 Startup
- 6. Remote Monitoring System (RMS) Description
- Appendix A. Fuel Line Selection
- Appendix B. Outline and System Drawings
- Appendix C. Wiring Diagrams
4. Installation 8-2019
40 A062J678 (Issue 2)Copyright © 2019 Cummins Inc.
No. Description No. Description
1 Exhaust Panel Screws 2 Exhaust Panel (Rear)
FIGURE 9. EXHAUST PANEL REMOVAL
c. Remove the exhaust panel.
d. Remove 2 screws securing the fuel selector access cover and
remove access cover.
No. Description No. Description
1 Fuel Selector Access Cover Screws 4 Access Opening
2 Fuel Selection Handle Access 5 Fuel Selector Valve
3 View from Face of Regulator (panels
not shown)
FIGURE 10. FUEL SELECTION ACCESS