Install Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Save These Instructions
- 1.2 General Information
- 1.3 General Precautions
- 1.4 Generator Set Voltage Is Deadly
- 1.5 Engine Exhaust Is Deadly
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Starting Batteries
- 1.9 Moving Parts Can Cause Severe Personal Injury or Death
- 1.10 The Hazards of Carbon Monoxide
- 2. Introduction
- 3. Pre-Installation Considerations
- 4. Installation
- 5. Startup and Configuration
- 5.1 "Establishing Communications" Message
- 5.2 "Clock Setup" Screen
- 5.3 "Exercise" Screen
- 5.4 "Brightness and Contrast" Screen
- 5.5 "About" Screen
- 5.6 "Event Log" Screen
- 5.7 "Fault Log" Screen
- 5.8 "System Status" Screen
- 5.9 "Mode" Screen
- 5.10 Automatic Load Management
- 5.11 Manual Start Sequence (Local)
- 5.12 Checklist
- 5.13 Startup
- 6. Remote Monitoring System (RMS) Description
- Appendix A. Fuel Line Selection
- Appendix B. Outline and System Drawings
- Appendix C. Wiring Diagrams
3. Pre-Installation Considerations 8-2019
18 A062J678 (Issue 2)Copyright © 2019 Cummins Inc.
TABLE 11. INSTALLATION CODES AND STANDARDS FOR SAFETY
RECOMMENDATIONS
Code or Standard Organization
NFPA 37 - Installation and Use of Stationary
Combustion Engines and Gas Turbines
NFPA 54 - National Fuel Gas Code
NFPA 58 - Storage and Handling of Liquefied
Petroleum Gases
NFPA 70 - National Electrical Code
National Fire Protection Association
470 Atlantic Avenue
Boston, MA 02210
CSA Electrical Bulletin
CSA 22.1 Canadian Electrical Code
CSA B149
CSA C22.2 No. 100
CSA C22.2 No. 14
Canadian Standards Association
Housing and Construction Materials
Section
178 Rexdale Blvd.
Rexdale, Ontario, Canada M9Q 1R3
California Administrative Code - Title 25 Chapter 3 State of California
Documents Section
P.O. Box 1015
North Highlands, CA 95660
Operating the Generator Set Cover Safely
To configure the local display or access the generator set, you will need to lift the
cover (lid). The cover of the generator set is designed to latch securely into the "up"
position to prevent accidental closure.
• To open: Lift the cover until the hinge pin drops into the hinge pin slot. Test
that the cover is secure by gently pressing down on the cover.
• To close: Lift up on the cover while pressing upward on the hinge pin and slide
the pin upwards out of the hinge pin slot. Carefully push the cover downward
and let go of the hinge pin allowing it to ride along the hinge until the cover is
closed.