Install Manual
Table Of Contents
- Table of Contents
- 1. Important Safety Instructions
- 1.1 Save These Instructions
- 1.2 General Information
- 1.3 General Precautions
- 1.4 Generator Set Voltage Is Deadly
- 1.5 Engine Exhaust Is Deadly
- 1.6 Fuel and Fumes Are Flammable
- 1.7 Batteries Can Explode
- 1.8 Starting Batteries
- 1.9 Moving Parts Can Cause Severe Personal Injury or Death
- 1.10 The Hazards of Carbon Monoxide
- 2. Introduction
- 3. Pre-Installation Considerations
- 4. Installation
- 5. Startup and Configuration
- 5.1 "Establishing Communications" Message
- 5.2 "Clock Setup" Screen
- 5.3 "Exercise" Screen
- 5.4 "Brightness and Contrast" Screen
- 5.5 "About" Screen
- 5.6 "Event Log" Screen
- 5.7 "Fault Log" Screen
- 5.8 "System Status" Screen
- 5.9 "Mode" Screen
- 5.10 Automatic Load Management
- 5.11 Manual Start Sequence (Local)
- 5.12 Checklist
- 5.13 Startup
- 6. Remote Monitoring System (RMS) Description
- Appendix A. Fuel Line Selection
- Appendix B. Outline and System Drawings
- Appendix C. Wiring Diagrams
17A062J678 (Issue 2) Copyright © 2019 Cummins Inc.
3 Pre-Installation Considerations
3.1 Pre-Installation Considerations Introduction
WARNING
The installer is responsible for complying with all applicable installation
codes and safety requirements. See the Installation Codes and Standards for
Safety section of this manual for more information.
The following sections create a step-by-step overview of a typical generator set
installation. Review these sections to become familiar with specific procedures and
important safety before beginning the installation.
NOTICE
For information on tools and materials, see the Required Items for
Installation section. For information on locating the generator set, see the
Installation section. For codes and standards, see the Installation Codes
and Standards for Safety section. For specifications, see the Model
Specification section.
NOTICE
Depending on the locality and use of the generator set, it may be necessary
to obtain an air quality emissions permit before installation begins. Check
with local pollution control or air quality authority to determine permit
requirements.
3.2 Installation Codes and Standards for Safety
NOTICE
The generator set installer bears sole responsibility for following all
applicable local codes and regulations.
The following list of codes and standards may apply to the installation and operation
of the generator set. This list is for reference only and not intended to be inclusive of
all applicable codes and standards. The address of each agency is listed so that
copies of the codes may be obtained for reference. Installation codes and
recommendations are subject to change, and may vary by location or over time.