Manualshelf

Product Manual

ManualsBrandsCummins Power Generation ManualsGenerator AccessoryCummins Local Emergency Stop Switch For RS13-RS100 Standby Generators
12345678910
Table Of Contents
Page 9 of 17A045H700 (Issue 5) Copyright © 2017 Cummins Inc.
FIGURE 4. RECOMMENDED LOCATION OF HOLE FOR E-STOP (GENERATOR SETS THAT REQUIRE HOLE
DRILLING ONLY)
10. Align and install the knob on the contact block:
• Generator sets with a display panel knockout only: Use the mounting nut to install the knob and
lockout guard on the display panel as shown in Figure 1.
• Generator sets with a display panel rubber plug only: Install the knob and lockout guard on the
display panel as shown in Figure 2.
• Generator sets that require hole drilling only: Install the knob and lockout guard on the
enclosure panel as shown in Figure 10.
11. Install the display panel (if applicable).
12. Route the emergency stop contact block wires as shown in the figures below.