Product Manual

ManualsBrandsCummins Onan ManualsInverter3,700 Watt Electric Start Portable Inverter Generator w/ Wireless Remote Start (CARB)

Table Of Contents

1-2019

A062R852 (Issue 1)

MANUAL START

Be sure to check oil levels before starting. If it is the rst

time starting make sure to add oil (see Initial Oil Fill on page

13).

1. Make sure nothing is plugged into any of the outlets.

2. Make sure battery is connected (see Hooking Up the

Battery on page 7).

3. Make sure the circuit breakers are properly set (see

Figure 6).

4. Turn the Fuel Control Switch to the ON position (see

Figure 7).

5. Turn the Engine Control Switch ON.

6. Firmly grasp and pull the recoil handle slowly until you

feel increased resistance. At this point, apply a rapid

pull while pulling out from the inverter (see Figure 9).

Figure 9: Pull the Recoil Handle out from Inverter

7. Once engine stabilizes. Plug in electronic devices.

DANGER

To prevent unintentional starting with

remote key fob the engine switch must be

OFF if the generator is inside or is outside

and not intended to be used for remote

start.

WIRELESS REMOTE START

1. Check oil levels.

2. Conrm Engine Control Switch is ON.

4. Conrm that the Fuel Control Switch is in the ON

position (see Figure 7).

5. Push and hold the START button on the wireless

remote until the inverter starts.

Note: the generator will try 3 times to make a successful

start.

ELECTRIC START

Be sure to check oil levels before starting. If it is the rst

time starting make sure to add oil (see Initial Oil Fill on

page 13).

1. Make sure nothing is plugged into any of the

outlets.

2. Make sure battery is connected (see Hooking Up

the Battery on page 7).

3. Make sure the circuit breakers are properly set

(see Figure 6).

Figure 6: Breakers

(1) 120V Circuit Breaker Operating Position

(2) 120V Circuit Breaker Tripped Position

4. Turn the Fuel Control Switch to the ON position

(see Figure 7).

Figure 7: Turn Fuel Switch to ON Position

5. Turn the Engine Control Switch ON.

6. Push and hold the engine start push button for 1

second and release (see Figure 8). The engine will

automatically set the choke and begin the start

sequence.

Figure 8: Electric Start Button - PUSH

Note: If the engine fails to start after 5 seconds, release the button.

Let the inverter sit idle for 15 seconds and then repeat step 6. If the

cranking speed drops after each unsuccessful attempt, then the

battery may not be adequately charged.

7. Once engine stabilizes. Plug in electronic devices.

OPERATION