Product Manual

3-3
3. Add or drain oil as necessary. See REC-
OMMENDED ENGINE OIL (p. 2-1). Keep the
oil level between the FULL and ADD marks.
CAUTION
Too much oil can cause high oil
consumption. Too little oil can cause severe
engine damage. Keep the oil level between
the FULL and ADD marks.
4. Reinsert the dipstick and secure the oil fill cap
and front access door.
CHANGING ENGINE OIL AND OIL FILTER
Refer to Table 3-1 for scheduled engine oil change.
Change oil more often in hot and dusty environ-
ments.
1. Place a pan under the oil drain plug (Fig-
ure 3-1), run the genset until warm and shut it
off.
2. Remove the front access door and the oil fill
cap, unscrew the oil drain plug and drain all the
oil from the engine. Reinstall the oil drain
plug securely.
3. Spin off the oil filter canister and clean the filter
mounting surface on the engine block. Remove
the old gasket if it remains.
4. Make sure the gasket is in place on the new fil-
ter and apply a thin film of clean oil to the gas-
ket. Spin the new filter on until the gasket just
touches the block. Turn it an additional 1/2 to
3/4 turn. Do not overtighten.
5. Refill with 5.9 quarts (5.6 liters) of oil, check oil
level (Figure 3-1) and secure the front access
door.
6. Dispose of the used oil and oil filter according
to local environmental regulations.
DRAIN PLUG
(22 MM HEX HEAD)
DIP STICK
FILTER
FILL CAP
FIGURE 3-1. ENGINE OIL MAINTENANCE