Specifications

Using an RO to service other water using appliances
You may be requested to attach a refrigerator, icemaker, or even a coffee maker to your RO system. The Aqua-Cleer Good Water
Machine can provide these appliances with crystal clear RO water, but there are a few important guidelines that must be followed
in order to install a proper distribution system. Please refer to page 27 for technical information that will assist these applications.
Start-Up
The following procedure should be performed during the plant pre-delivery check out and again after installation:
• Turn on the inlet feed water valve and open the tank valve.
• Check system thoroughly for leaks.
• Run product water from faucet to flush carbon dust out of the carbon post-filter.
• Verify proper module performance.
Overall System Check
• Turn on the inlet feed water valve and open the tank valve. A complete systems check can be performed when the reservoir
tank has been precharged with water.
• Move the faucet lever to the full open position. A steady stream of product water should be observed if the tank was filled
earlier.
• Make a complete system check and adjust as needed to correct any leaks.
• Run product water through the faucet to flush out any remaining carbon dust from the post filter.
• Perform a final module check to verify proper product performance.
• Thoroughly clean up the equipment and the installation site.
Review Operation With Customer
Review the operation of the Culligan
®
drinking water system with the customer. Explain that the unit will require routine
maintenance of the prefilters, reverse osmosis membrane filter, and the polishing filter. Advise the customer how often these items
will need to be serviced based on your past experience. Discuss the product and module warranties.
18 Aqua-Cleer
®
/ Good Water Machine
®