Specifications

Preassembly
Base Installation
1. The faucet will separate from the base with a 1/4 counter-clockwise turn. This will allow for you to do all of the mechanical
installation of the faucet from the top of the sink (see figure 9).
2. Center the gasket over the 1-1/4” sink hole. Place the faucet base on top of the gasket and push the toggle bolts through the
sink hole.
3. Center to base over the hole with the Culligan logo facing forward and tighten the screws in a clockwise rotation.
4. You may need to use your finger to guide the toggles as you tighten the screws. Once the screws are tightened and seated
the base installation is now complete.
CAUTION! Plastic Parts will break if screws are over tightened,
Tubing Connections
1. At the bottom of the faucet assembly you will find three tubing connections; 2 are barbed and one is a push in type fitting.
2. For the Air gap you will use the 2 barb fittings, the smaller fitting is for the 1/4” tubing and will be connected to the RO system.
The larger barb fitting will use the 3/8” tubing and will be connected to the drain. Run some warm water over the end of each
tube and push them onto the selected barb fittings.
NOTICE: Cut the tubing to be longer than what you will need because you will be able to trim it after you install the faucet
assembly. Prepare the tubing with a fresh cut and make sure that it is free of dirt and any foreign materials.
3. Take another length of 3/8” tubing and make sure it is has a fresh cut and is free of foreign materials and any scratches on
the outside surface. Install the tubing into the push in type fitting at the base of the faucet. Make certain that it is inserted
all the way in; once inserted give it a slight pull to make sure it is locked into the fitting. You have now completed the tubing
connections.
NOTICE: To disconnect tubing from the product water fitting, hold the collet firmly against fitting body and pull the tube from
the fitting. Repeated assembly and disassembly will cause wear to the inner body. Visually inspect for excessive wear and
replace the inner body as needed to protect against any leaks.
4. Feed the monitor cable, if used, down through the faucet base. Be sure that all twists are eliminated from the cable.
Final Installation
1. You will find two handle selections with the faucet. Choose one and install it buy removing the screw and slipping the handle
into place (see figure 9).
2. You are now ready to install the faucet into the base assembly that is mounted on the sink. First guide the tubing into the
center of the base assembly and feed them through until the faucet reaches the base.
3. Decide if you want the handle to be on the left or right side. Hold the base securely with your free hand and insert the faucet
into the base and turn it clockwise 1/4 turn.
4. Once the faucet is securely attached to the base the installation of the faucet is complete.
5. Next step is to attach the tubing to the RO system and the drain connection according to the normal installation instructions for
the RO system.
Installation 15