Specifications

The following steps will enable you to install the system quickly and orderly. Some variation may be necessary depending on the
installation. See page 5 for a check list of tools and materials.
The flat-bottom design of the filter housings allows the option of standing the filter system assembly on the cabinet floor rather than
mounting it to the wall. The filter assembly is reversible on the mounting bracket.
Typical installations follow this sequence:
• Select Component Installation Locations.
• Clear and Prepare Area.
• Install Faucet.
• Provide Inlet Water Supply.
• Provide Drain Connection
• Install Reservoir Tank.
• Install Filter System Assembly.
• Connect All System Components.
• Start-Up
• Performance Check
• Clean up Work Area.
• Review Operation with Customer.
Select Component Installation Locations
• Dispenser Faucet - The Culligan
®
faucet is designed to be mounted on the rear lip of the sink. It may be installed in an
existing sprayer attachment hole or in a hole drilled at the time of installation. It may also be mounted to an adjacent counter
top. It should be positioned so that water is dispensed over the sink. A minimum 1-1/4” diameter hole is required.
When installing the Aqua-Cleer Sentry
™
water quality monitor, refer to the installation instructions packaged with the monitor.
Make certain the TDS level setting corresponds to the customer’s water supply.
• Important considerations:
• Access to the bottom (undersink) of the faucet is required for attachment of product water line.
• The faucet can be installed for left- or right-handed operation.
• There should be no undersink obstructions which would prevent smooth tubing runs to the drain connection, carbon post-
filter, or RO module assembly.
• Filter System Assembly - The filter system assembly is designed to be mounted on any rigid vertical surface such as a
cabinet sidewall or basement rafter. It should be positioned such that there is access to an inlet water source and drain. The
installation should also allow convenient access for servicing.
• Inlet Water Supply Connection - Once a location is chosen for installation of the filter system assembly, select a nearby cold
water line to provide the water source for the system. For undersink installations, the cold water faucet line can usually be
tapped.
NOTE: Follow all local plumbing codes when connecting to service water.
12 Aqua-Cleer
®
/ Good Water Machine
®