Specifications

17
Programming
Thetimerusesfourbuttons:
Button Description
Set-up/EnterKey(Status)
Advance timer through display options
Regeneration Key (REGEN) Initiate a regeneration
ToggleDownKey(“-”)
Decrease the setting
ToggleUpKey(“+”)
Increase the setting
Time of Day
This setting is used to program the current time
ofday.Wheninthisstepthedisplaywillrst
show “tod” for two seconds.
After“tod”isdisplayed,“12:00PM”willdisplay
(or the current set time if already programmed)
andtheminuteswillash.
• The minutes are adjusted with the
“+”or“-”keyuntilthecorrectvalueis
displayed.
 •Pressthe“Regen”keytoashthe
hours.Adjustwiththe“+”or“-”key
until the correct time is displayed.
Pressing the “Status” key will move to the next
programming step. Pressing “Regen” will move
back to the minutes adjust.
Time of Regeneration
This setting is used to program the time at
which a regeneration is to occur in the delay
mode, or in immediate mode with time clock
backupon.Thedisplaywillrstshow“tor”for
two seconds.
After “tor” is shown the display will then
showthedefaultof2:00AM(orthecurrent
programmed time of regeneration if already
set).Thetimecanbeadjustedin30minute
incrementsbypressingthe“+”or“-”keys.
Pressing the “Status” key will save the setting
and move to the next programming step.