Specifications

Installation

(cont.)

Soft-Minder

Meter Connection

ToconnectthemeterleadsrefertoFigure20andproceedasfollows:

• Lift up the timer case from

the back plate.

• Remove the small plastic

plug from the backplate.

• Slip the meter harness

through the hole and

toward the circuit board.

• Connect the harness to

the circuit board. The

Soft-Minder

meter

terminal is labeled

“FLOWMETER”.

• Pull any excess cable

wire back out of the

enclosure, and route

the wiring inside the

enclosure to avoid any

interference with moving

parts.

• Locate the strain relief

bushing in the parts pack.

Place it on the cable at

the point of entry to the

rear of the timer plate and

push it into the hole.

Electrical Connections

Thepowercordneedstobeconnectedtotheplug-in

transformer,wireorientationisnotcritical.Figure21shows

the cord attachment to the transformer. Connect wire

harnessto24VACterminalsontransformer.

Note: Observe all state and local electrical codes.

Note: The plug-in transformer is rated for indoor

installations only.

Note: The wire connectors must be connected to the circuit board properly. The wires must exit

the plug-in connector opposite of the raised white base of the circuit board connector. Failure to

properly connect any of the connectors will result in a malfunction of the circuit board operation.

Figure20