Specifications

Installation
(cont.)
11
Unit Backwash Flow Nozzle Throat Brine Refill Flow
8” #1,Black* Blue* LightBrown* 0.45gpm
Medallist30 #2,Brown*
Blue* LightBrown* 0.45gpm
Medallist 45 #2,Brown
@6lbs-Blue
Greater than
6lbs-Beige
LightBrown 0.45gpm
Medallist60
#3, Green Beige LightBrown 0.8gpm
*Standardfromfactory.
Refertogure13foravisualonchangingthe
eductornozzleandthebackwashowcontrol.
Eductor Nozzle Replacement:
• Remove the three screws on the eductor cap
and remove the cap.
• Remove the eductor assembly.
• Remove the eductor screen from the assembly
• Remove the blue nozzle and replace it with the
beigenozzle.Makesuretoputtheo-ringon
the beige nozzle.
• Reverse the procedure to reassemble. To
prevent leaks, ensure that the gasket is in the
proper position.
Backwash Flow Control
Replacement:
• Remove the drain clip and pull the drain elbow straight off.
• Removethebackwashowcontrollocatedbehindtheelbow.
Note: The number on the flow control should face into the valve body.
• Reverse the procedure to reassemble.
Plumbing Connections
General Instructions
• Follow local plumbing & electrical codes. Failure to do so may result in your having to redo the
installation at your expense.
• Takethetimetomakeaclean,professionallookinginstallation.Useuxandsoldersparingly
when making sweat connections, and avoid excessive use of pipe compound. When using
galvanized pipe, clean out excess cutting oil and metal chips before assembly. Foreign objects,
if allowed to enter the control valve, can cause operating problems.
• The main water supply line may then be reopened so that hard water will be available to the
householdthroughouttheremainderoftheinstallationprocess.SettheCul-Flo-ValveBypassin
the bypass position by screwing the stem all the way in against the body.
Caution! Close the inlet supply line and relieve system pressure before cutting into the
plumbing! Flooding could result if not done!
Figure13